Tools
From the design to a finished link
The calculators stand in the order the work goes. Pick the step you are at.
Planning
Before going on site you work out whether the link will pass and prepare what the crew takes with it. After the build you set the calculation against the measurement.
Fiber splice diagramTick the fibers, press Splice, and get the diagram of a closure or a patch panel.
you entercables and which fibers go whereyou geta splice diagram
Link loss budgetA point-to-point link: fiber, connectors and splices against the transmitter and the receiver.
you enterlength, connectors, splicesyou getloss, margin, the longest link
PON power budgetA tree or a bus: splitters and unbalanced taps down to every ONT.
you enterthe class and the cascadesyou getloss and margin on every branch
Before the shot
You are at the instrument, choosing the settings. A mistake here costs a second shot.
What pulse the instrument would setA lookup in one instrument's table: what it would choose on your line.
you enterline length and splitteryou getrange, pulse, averages
Dead zone and launch cableHow many metres after a connector the instrument cannot see, and whether your launch cable is long enough.
you enterpulse and launch cable lengthyou getthe dead zone and a verdict
Reading the trace
The trace is shot, and a distance on it has to become a place on the cable and on the ground.
A distance at another index of refractionThe instrument had one index, the cable datasheet gives another.
you entera distance and two indexesyou getthe new distance and the shift
Distance to a fault on the groundThe instrument measures fiber, and people dig along the ground. The answer is a window.
you enterthe reading and the cable typeyou geta window along the cable and the ground
At the closure
The cable is open, and the right fiber has to be found by its color.
Set the calculation against the trace
Open the trace in OTDR Master and put the measured figures next to the calculated ones.